Configuring VRRP load balancing

For VRRP to operate correctly in load balancing mode, make sure the virtual IP address of an IPv4 VRRP group is not the IP address of any interfaces in the VRRP group.

Examples

# Configure VLAN 2.

<SwitchA> system-view

[SwitchA] vlan 2

[SwitchA-vlan2] port gigabitethernet 1/0/5

[SwitchA-vlan2] quit

# Configure VRRP to operate in load balancing mode.

[SwitchA] vrrp mode load-balance

# Create VRRP group 1, and set its virtual IP address to 10.1.1.1.

[SwitchA] interface vlan-interface 2

[SwitchA-Vlan-interface2] ip address 10.1.1.2 24

[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1