An experience case where remote configuration synchronization does not take effect at a site
- 0 Followed
- 0Collected ，716Browsed
Network Topology
Typical AC-FIT AP Scenario
Problem Description
The customer creates a new service VLAN on the ap template of the ac and releases it through the wired port. If you want to send the configuration through remote configuration synchronization (not a map file), the customer configuration is as follow.
|
wlan ap ap2 model WA5530 remote configuration enable vlan 1 vlan 2 to 4 radio 1 service-template 1 vlan-group 1 radio 2 radio 3 gigabitethernet 1 gigabitethernet 2 port link-type trunk port trunk permit vlan all |
The customer has configured the remote configuration synchronization function, but the remote login to the ap view, the VLAN-related configuration has not been delivered.
Process Analysis
remote-configuration enable This command, if the ap is already online, configure this command alone, and the vlan-related configuration will not be issued. It needs to be configured at the same time: The remote configuration syschronize command works together.
If the ap is not online, the configuration will automatically take effect after it goes online
Solution
Take the AP offline and back online again, and the configuration will take effect. (or add remote-configuration syschronize command)