The switch of the same model has inconsistent STP display information after STP is turned off.
- 0 Followed
- 0Collected ，1997Browsed
Network Topology
none
Problem Description
SW1：
<H3C>dis stp
STP is not configured. <H3C>dis version
H3C Comware Software, Version 7.1.070, Release 1311P02
Copyright (c) 2004-2018 New H3C Technologies Co., Ltd. All rights reserved.
H3C S5560-54C-EI uptime is 1 weeks, 4 days, 7 hours, 1 minute
SW2：
[H3C] dis stp
Protocol status : Disabled
Protocol Std. : IEEE 802.1s
Version : 3
Bridge-Prio. : 32768
MAC address : 00a0-5560-54c0
Max age(s) : 20
Forward delay(s) : 15
Hello time(s) : 2
Max hops : 20
TC Snooping : Disabled
[H3C] dis version
H3C Comware Software, Version 7.1.070, Release 1311P02
Copyright (c) 2004-2018 New H3C Technologies Co., Ltd. All rights reserved.
H3C S5560-54C-EI uptime is 45weeks, 6 days, 9 hours, 46 minute
Process Analysis
SW1: When STP is never enabled, that is, when the device starts, it is "undo stp enable", and the STP process has never been created, it will display "STP is not configured."
SW2: As long as it is enabled once, the STP process has been created. Once the STP process starts, it will not exit, even if it is turned off again, it will still display the status of STP.
Solution
The device operates normally and does not require attention to the processing mechanism.