Experience case of fail to open automation switch when expanding device in ADDC solution

On-site device expansion is required. When opening the Fabric automation switch, the message specified device Netconf request fail appears as shown below:

1. First, check the device status as active on the pool-device resource-physical device page, indicating that the netconf over ssh connection is normal.

2. Check the account configuration used for management on the device. The HTTPS service is not enabled.

3. After confirmation, the controller (CTL) side operates the device automation switch through the netconf HTTPS channel, which requires the device to enable HTTPS.

After adding the HTTPS service under local-user sdn, enabling the automation switch works normally